Filter
Top Products
Heat & Glo • 8000CF-OAK-IPI • 2059-900 Rev. Q • 11/0832
A. Attaching Sheetrock Ledges
Attach sheetrock ledges together using the attachment
holes (see Figure 9.1).
Figure 9.1
The sheetrock ledges will attach to the top of the unit (see
Figure 9.2).
Figure 9.2
Attach previous assembly to the top of the unit using the
provided slots. The face of the sheetrock ledge assembly
and the unit surround should be fl ush to each other.
Figure 9.3
SEE DETAIL B
CLEARANCE SLOT
SHEETROCK
LEDGE
UNIT
SURROUND
ATTACHMENT
HOLES
6 PLACES
DETAIL B
B. Temporary Access Panel
Remove the lower access panel to run the electrical and
gas lines to the unit (see Figure 9.3).
Once the electrical and gas lines are hooked up, the lower
access panel must be put back on the unit.
LOWER
ACCESS PANEL
SEE DETAIL A
DETAIL A
ATTACHMENT
HOLES
NAILING
TAB
9
9
Appliance Preparation