Filter
Top Products
Heat & Glo • 6000GCF-IPI, 6000GCF-IPILP • 2110-900 Rev. H • 11/08 47
G. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• Place dime-size pieces of Glowing Embers® just in front
of the port trail, but not on or in between the ports (see
Figure 14.7). Care should be taken so that the ports are
not covered. Failure to follow this procedure will likely
cause lighting and sooting problems.
Figure 14.7 Placement of Embers
• Place Mystic Embers on areas of base refractory away
from port holes. Use this material to give the appliance
a realistic ash bed.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
STEP 1.
Place the back piece of refractory in back of the fi rebox.
The small indentation on one side goes down. Lean the
refractory slightly so it doesn’t tip over.
Figure 14.4
Figure 14.5
F. Install the Refractory
Note: The red refractory will naturally darken when the
fi rebox heats up. The red color will return when the fi rebox
cools.
STEP 2.
Place the left side refractory onto the left side of the burner.
Push the back refractory against the back wall. Place the
bumps on the bottom of the left refractory into the grooves
on the burner surface. Push to top gently against the side
of the fi replace. Once in place push it back so the bevel
cuts sit against each other and the seam is minimized.
Figure 14.6
STEP 3.
Repeat step 2 for the right side.
EMBER MATERIAL