September 1, 2008
7033-277F
Page 5
R
1. Remove all ash from the rebox, and extinguish all hot
embers before disposal into a metal container.
2. The bafe board has 2 pieces. With the ceramic blanket
still in place, slide one bafe piece over the top of other one
and pull out top piece through the door opening and then
remove bottom bafe piece.
. Remove the ceramic blanket.
4. Re-install the bafe pieces one piece at a time. Be sure
the bafe boards are even with the front manifold tube and
is resting on all tubes.
5. To re-install the ceramic blanket, it is easier to fold it in
half rst. Place on top of bafe board, open up and atten
and smooth out the blanket. Re-check the bafe board for
correct positioning.
Magnet
Spade
Connectors
Snap Disc
1. Locate the snap disc bracket assembly at the bottom left
rear corner of the stove.
2. A magnet holds the bracket to the stove. Pull the bracket
down away from the stove to expose the snap disc.
. Pull the snap disc and spade connectors up and out of
bracket as shown in
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the stove.
Snap Disc Location