Page 4
7033-277F
September 1, 2008
R
Replace the rebrick if they become crumbly and/or if there
is a 1/4 inch (6.5mm) gap between the bricks.
Inspect the rebrick after each ash removal.
The rebox is lined with high quality rebrick, which has
exceptional insulating properties. There is no need to use a
grate; simply build a re on the rebox oor. Do not operate
appliance without rebrick.
1. After the coals have completely cooled, remove all old
brick and ash from unit and vacuum rebox.
2. Remove new brick set from box and lay out to diagram
shown.
. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of rebox wall and push
bottom of brick back.
5. Install side bricks. Slide top of brick under clips on side
of rebox and push the bottom of the brick until it is ush
with the side of the appliance.
Use Part 82-0550 when ordering individual brick. Provide brick
dimension or copy this page, mark the desired brick and take it
to your authorized dealer.
Brick Size
1 9 x 4-1/2 x 1-1/4 12
2 6 x 4-1/2 4
3 9 x 4-1/2 with angle (see drawing) 1
4 9 x with angle (see drawing) 1
Brick Size
1 9 x 4-1/2 x 1-1/4 10
2 6 x 4-1/2 4
3 9 x 4-1/2 with angle (see drawing) 1
4 4-1/2 x 4-1/2 x 1-1/4 2
5 9 x with angle (see drawing) 1
1
1
1
1
1
1
1
1
1
2
2
2
2
3
4
1
1
1
3
5 in.
2 in.
2 in.
1-1/4 in.
9 in.
1-1/4 in.
8 in.
3 in.
1-1/4 in.
4
NOTE: The Ash Removal System is avail-
3
5 in.
2 in.
2 in.
1-1/4 in.
9 in.
1-1/4 in.
2
2
2
2
1
1
1
1
1
1
1
1
1
1
4
4
5
3
No brick, ARS
Grate Location
8 in.
3 in.
1-1/4 in.
5