Filter
Top Products
September 1, 2008
7039-131F
Page 29
2100 Millennium Wood Stove (ACC)
R
Replace the rebrick if they become crumbly and/or if
there is a 1/4 inch (6.5mm) gap between the bricks.
Inspect the rebrick after each ash removal.
The rebox is lined with high quality rebrick, which has
exceptional insulating properties. There is no need to
use a grate; simply build a re on the rebox oor. Do
not operate appliance without rebrick.
1. After the coals have completely cooled, remove all
old brick and ash from unit and vacuum rebox.
2. Remove new brick set from box and lay out to
diagram shown.
. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks.
Slide top of bricks under clip on back of rebox wall
and push bottom of brick back.
5. Install side bricks. Slide top of brick under clips
on side of rebox and push the bottom of the brick
until it is ush with the side of the unit.
C. Firebrick Replacement
Use Part 82-0550 when ordering individual brick. Provide brick
dimension or copy this page, mark the desired brick and take it
to your authorized dealer.
4
1-3/8 in.
(35mm)
1-3/4 in.
(44mm)
6-1/4 inches
(159mm)
8-1/2 inches (216mm)
1
11
1
1
1
1
1
1
2
2
2
4
3
3
5
8-1/2 inches (216mm)
3 inches
(76mm)
7 inches (178mm)
5
Figure 29.1
No. Brick Size Qty
1 9 x 4-1/2 x 1-1/4 9
2 6 x 4-1/2 3
3 8 x 4-1/2 x 1-1/4 2
4 Brick with angle (see drawing) 1
5 Brick with angle (see drawing) 1