Filter
Top Products
KK-K9-F14-K_INST_11-08
5
.
2. The holes in mounting plates will line up with OEM seat mount holes. Bolt the plate and leg
assembly to vehicle using OEM seat bolts. Adjust leg height to 7 ¾” inch.
3. Slide K9 main housing into vehicle:
Remove plastic storage compartment
INSTALLATION:
Note: The K9 unit will not slide into rear hatch opening without removing ream d
trim panels. Side tunnels must also be removed.
oor
ht adjustable front legs with ¼” x ¾” carriage bolts and serrated
1 Attach floor mounting plates to heig
nuts. (Photos 1 and 2)
1
2
Note: Mounting plate
7 ¾”
straddles a ridge in the
floor. When bolts are
tightened the plate will
form to the floor.
Using factory seat bolts; attach driver
and passenger side mounting plates
and legs as shown above.
Set height at 7 ¾”
When positioned properly, holes
in K9 floor will align with holes in
mounting legs.
3
4