Filter
Top Products
22
Dry Seasoned Wood Only! 3-90-08560 Save These Instructions
The optional blower kit installs easily to the rear of
the TL2.0. First, remove the air jacket shield from the
rear of the stove. Use the same four bolts to attach
the blower as shown.
The top air grill installs over the ue collar and simply
rests on the top of the stove. The brushed stainless
grill is included with this option as well.
The trim kit consists of three pieces; Load door trim,
Ash lip trim, and the Ash door frame. To install the load
door trim, it is best to remove the door by lifting from
the hinges. lay the door down at on it's face. Drill the
dimpled holes in each corner of the door and re-install
the door onto the stove. From the outside, install the
frame with the studs going through the newly drilled
holes and install the nuts on the inside. To install the
ash lip trim, just slide it onto the ash lip. You may attach
with silicone if desired. The ash door frame uses a
spring clip on one end to hold it into the recessed area
of the ash door. Install the clip in the frame channel
and push that end into the door opening until the other
end of the frame ts.
Plug the blower into a properly grounded electrical
outlet.
Keep the blower on low speed or off during low res.
As you get out of the low burn range, the speed can
be set wherever desired, or kept off.