Filter
Top Products
5
The sheet metal top and sides can be easily
removed to reduce the chance of dents or
scratches on the painted surfaces.
To remove the sheet metal, rst lift off the
top section. Now, the sides can be removed by
lifting up and out away from the furnace.
To lighten the SF2600, the oil burner heat
exchanger should be removed. Do so by rst
removing the sheet metal as described above.
Remove the front sheet metal by rst removing
the burner collar. Now remove the the two
long bolts on each side of the heat exchanger.
(Figure B) The entire unit can now be lifted off
and moved separately.
Locate the furnace as close to the chimney as possible while still
maintaining the above clearances. No more than 8 feet of stovepipe
should be used, including two or less 90° elbows. All horizontal
runs of pipe should have a minimum 1/4 in. rise per foot. All stove
pipe must be 24 gauge or thicker.
When re-installing the heat exchanger, inspect the gasket around
the furnace opening, and replace if necessary. (Figure A) Place the
heat exchanger in position and secure with the long bolts and nuts.
Be sure the gasket is compressed evenly.
Re-install the sheet metal by sliding the groove on the bottom
of each side panel over the steel lip on the furnace. The top sheet
metal piece holds the sides in place. The SF2600 front cover gets
installed by angling the bottom edge over the lip on the top of the
rebox. The side edges must slide into the grooves on each side
and pushed in ush with the sides and top. This front piece is held
in place by the black ring which gets tightened around the burner
pipe. Do not over tighten as this will push the sheet metal in too far.
Inspect Gasket prior to re-
installing heat exchanger.
(4) 12in. bolts, two on
each side, attach the heat
exchanger to the furnace.