Filter
Top Products
Page 3
SKU 95267
6. Dress properly. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Protective, electrically nonconductive clothes and nonskid footwear are
recommended when working. Wear restrictive hair covering to contain long hair.
7. Use eye and ear protection. Always wear ANSI-approved impact safety goggles.
Wear an ANSI-approved dust mask or respirator when working around metal, wood,
and chemical dusts and mists.
8. Do not overreach. Keep proper footing and balance at all times. Do not reach over or
across running machines.
9. Maintain pump with care. Inspect tool cords periodically and, if damaged, have them
repaired by an authorized technician. Disconnect electrical source before performing
any maintenance or troubleshooting.
10. Avoid unintentional starting. Dry running of the pump causes excess wear.
11. Stay alert. Watch what you are doing, use common sense. Do not operate any pump
when you are tired.
12. Check for damaged parts. Before using any pump, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function.
13. Guard against electric shock. Prevent body contact with grounded surfaces such
as pipes, radiators, ranges, and refrigerator enclosures. It is strongly recommended
that this pump be plugged into a Ground Fault Circuit Interrupter (GFCI). Ask a local
electrician for easy installation instructions. To avoid electrical shock, no person or
animal should be in contact with the water being pumped. Never walk on wet or
damp area when pump is running in the same room.
14. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty.
15. Do not operate pump if under the influence of alcohol or drugs. Read warning
labels on prescriptions to determine if your judgment or reflexes are impaired while
taking drugs. If there is any doubt, do not operate the pump.
16. Use proper size and type extension cord. If an extension cord is required, it must be
of the proper size and type to supply the correct current to the tool without heating up.
Otherwise, the extension cord could melt and catch fire, or cause electrical damage
to the tool. This tool requires use of an extension cord of 0 to 10 amps capability (up
to 50 feet), with wire size rated at 18 AWG. Longer extension cords require larger size
wire. If you are using the tool outdoors, use an extension cord rated for outdoor use.
(signified by “WA” on the jacket). Note: Do not make the extension cord connection
underwater.
17. Do not pump hazardous materials. Do not pump explosive or flammable materials
such as Fuel Oil, Kerosene, Gasoline etc. Do not pump in close proximity to
flammable or explosive materials. Do not pump fats, oils, salt or waste water. This
Pump is designed to move clean or dirty water. Do not pump hot liquid.