Filter
Top Products
Page 4SKU 36711 For technical questions, please call 1-800-444-3353
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure that the product is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the cover of
this manual as soon as possible.
Operation
Note: When using the Heater for the first few times, an odor may be noticed. The odor is a
remnant from the moulding process and will dissipate after several minutes of
operation.
Warning!! When not in use and when the vehicle’s engine is OFF, unplug the Heater
from the 12 Volt power source.
1. Make sure the vehicle engine is running when operating the Heater.
2. Mount the Heater on the dashboard or any location in your vehicle where you can
operate the controls. The Heater comes with a mounting bracket that will allow you to
pivot the Heater once it is mounted. The mounting bracket should be separated from
the heater by firmly pulling the bracket with one hand while holding the heater in your
other hand.
3. Next attach the mounting bracket using screws or the supplied double sided tape.
Note: Before drilling any holes make sure there are no wires or cables in the drilling path.
4. Re-attach the Heater to the mounting bracket by firmly pressing it back on the round
holders on the sides of the Heater.
5. Insert the 12 Volt plug into the vehicle’s DC power inlet (cigarette lighter).
6. Turn the switch on the side of the unit to FAN or HEAT position. The Fan setting blows
air only. The HEAT setting blows out heated air.
Warning! Do not operate the unit for more than 15-20 minutes at a time.
7. When finished, turn the switch to “OFF” and unplug the unit.
Note: Make sure the air openings on the Heater are clear of dirt or debris.