Filter
Top Products
4
Connect the hot and cold supply hoses to the stops
with 3/8” compression fittings (not included). Tighten
wrench tight.
Re-set the High Temperature Limit Stop
(optional):
Remove the screw cover. Loosen the handle screw 2
complete turns.
Remove the handle.
Remove the nut cover and the high temperature limit
stop.
Replace the high temperature limit stop so that the
pin goes through the desired hole. The temperatures
shown on the diagram assume an incoming cold
water temperature of 50
o
and an incoming hot water
temperature of 140
o
F.
4
5
6