4
Install the pop-up drain
• Remove the plunger assembly.
• Unscrew the drain outlet flange from the tee.
• Unscrew the tailpiece from the tee. Wrap the threads with plumbers’ thread
tape and replace.
• Install the white, flexible sealing gasket to the flange. Sit it in the sink outlet.
• From under the sink, install the black mack gasket, white friction ring , and
retainer nut to the flange. Do not tighten the nut against the bottom of the sink
at this time.
• Thread the tee and tailpiece to the flange. The pivot must face the faucet. If
necessary, turn the drain assembly.
• Tighten the retainer nut.
• Sit the plunger assembly in the drain.
• Install the horizontal rod so that the end goes through the loop in the bottom
of the height adjuster.
• Install and hand tighten the pivot ball nut.
• Attach the swivel connector to the end of the horizontal rod.
• Attach the swivel connector to the end of the vertical rod. Position as
desired, and tighten with a small, flathead screwdriver.