Filter
Top Products
6
Reset the High Temperature Limit Stop (optional)
Use a 4 mm Allen wrench to push the screw
cover into the handle
Use the 4mm Allen wrench to loosen the handle
screw 4 complete revolutions. Remove the
handle.
Remove the nut cover.
Remove the handle screw from the stem of the
cartridge.
Remove the high temperature limit stop.
Replace the nut cover. Replace the handle
screw. Use the Allen wrench to turn the screw 4
revolutions.
Replace the handle. Finish tightening the handle
screw. Turn on the water and test the faucet.
Replace the high temperature limit stop so that the
pin on the cartridge is in the desired slot on the
limit stop. Note: the temperatures given in the
diagram assume a water heater temperature of
140
°
F, a cold water temperature of 50
°
F and a
water pressure of 45 PSI.
English