Filter
Top Products
3
Install baseplate 06329XXX,
(optional - not included)
Position the baseplate and gasket on the
faucet deck. From under the sink, install
the mounting flanges and tighten the
mounting collars by hand.
The baseplate can be used on a kitchen
sink with fewer than three holes. Remove
and disgard the threaded studs on the
bottom of the baseplate. Align the
baseplate and the gasket visually.
Install the faucet:
Remove the mounting nut, metal washer,
fiber washer and spacer from the faucet.
Sit the faucet on the mounting surface.
If the mounting surface is thin (less than 1
3/8”) and there is sufficent space, install the
gray plastic spacer. If the mounting surface
is greater than 1 3/8”, or if there is insuf-
ficient space, omit the spacer.
Loosely install the fiber washer, metal washer
and mounting nut.
Check the orientation of the faucet. The spout
swivels 150
o
and should swivel evenly to the
right and to the left. If it is satisfactory, finish
tightening the mounting nut and the tension-
ing screws.
Install the handspray hose:
slide the nut, cone washer, brass
washer and black rubber washer
over the end of the connecting hose.
Hold the handspray hose steady
while tightening the nut. Do not
allow the handspray hose to
twist. Finish tightening the nut with
a wrench.