Filter
Top Products
7
2
Locate the black carbon
pre-filter. It will be folded inside
a plastic bag. Remove and
discard the plastic bag.
Unfold and flatten out the black
carbon pre-filter. Attach the four
corners of the carbon pre-filter
to the four hook fasteners on
the HEPA filter.
Insert the two tabs on the
bottom of the intake grille into
the holes on the bottom ledge of
the air purifier. Pivot the intake
grille into place and lightly press
on the upper corners of the grille
to snap it into place.
NOTE: The air purifier has a
safety switch that prevents
operation if the intake grille is
not properly installed. DO NOT
attempt to override or disable
this safety switch.
3
4
NOTE: The carbon pre-filter
should be replaced approxi-
mately every three months.
Remove the intake grille by
carefully pulling the upper two
side tabs away from the body
of the air purifier and lifting up.
Installing the Carbon Pre-Filter
1
Setting the Controls
WARNING: To reduce the risk of electrical shock, never
plug in the air purifier while your hands are wet. Always
unplug the air purifier before moving or servicing the unit.
6
1. Power On Indicator –
Lights when unit is on.
2. Fan Speed Knob – Turn the
fan speed knob to the desired
setting. There are four settings:
• OFF
• WHISPERCLEAN
™
– Use for
quiet, nighttime operation or
for constant low-speed filtra-
tion.
• MED (Medium) – Provides a
higher fan speed; use for
quickly filtering dust, pollen,
smoke, etc. from a room.
• QUICKCLEAN
™
– Provides
cleaning during acute needs.
840115800 ENv00.qxd 6/6/03 9:02 AM Page 6