Haier HTWR10XCK Air Conditioner User Manual


  Open as PDF
of 36
 
Fig.B
Mounting tabs can be bent or cut off if not needed.Please use
the correct holes to match the sleeve.
Fig.C
On 26
3/4”-27” sleeves:Use existing rear grille and redirect
louvers
to 60 angle as shown in Fig.C
5
5.If the depth of your existing wall sleeve is less than or equal
WR´VNLSWRVWHS2WKHUZLVHFXWWKHEDIÀHVDQGWKHVXSSRUW
blocks according to length“A” in the table below.
6.Remove the backing from the support blocks and attach
them to the inside of the wall sleeve as shown FIG E.Slide the
EDIÀHLQWRVROWVRIWKHVXSSRUWEORFNV
8.Install the 1”x1
1/2”x84”long stuffer seal between the wall
sleeve and the unit.
9.To assemble trim,snap the tab of each piece into the slot of
the other piece as shown below.2-Trim frames are supplied
ZLWKXQLWXVHWKHWULPIUDPHWKDWEHVW¿WV\RXUVOHHYH
6OLGHWULPRYHUWKHIURQWRIWKHDLUFRQGLWLRQHUXQWLOWULPLVÀXVK
with sleeve as shown below.
Note:Be sure to route the cord through the trim frame before
placing the trim frame on the unit.
7.Install the new unit into the wall sleeve.
Depth“D” of the
existing wall
sleeve(inches)
Length“A”
inches
20<D<20
20 <D<21
21 <D<24
1-
4
5
8
3
4
3
4
5
8
3
4
3
4
A
A
Fig.D
Tapered Spacer
Block Board
FRONT
Wall
Sleeve
Wall
Fig.E
Tapered Spacer
Block
6
1
2
”
Assemble Trim
Fig.F
 previous next