Filter
Top Products
Outdoor Unit
4
Loading of the battery
1
2
3
4
Parts and Functions
Indoor Unit
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
e" + "/"-";
Load the battery,then put on the cover again.
Clock set
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press
change quickly.
After time setting is confirmed,press SET,
"AM "and "PM" stop flashing,while clock starts working.
or decrease 1min. If the
button is kept pressed,time will
will increase
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
wireless telephone is installed in the
ver is apt to be disturbed in receiving
the signals,
so the distance to the indoor unit should be sho
rter.
type fluorescent lamp or
room, the recei
Note:
Full display or unclear display during operation indicates the
ries have been used up.
Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
batte
remove the batteries and
Remove the batteries in case unit won't be in usage for a long period.
If there are any display
after taking-out, just need to press reset key.
Hint:
Actual indoop unit may vary from the one shown
in the manual, according to the product purchased.
Inlet
grille
Air Purifying
Outlet
Horizontal flap
(adjust up and down air flow
Don't adjust it manually)
(adjust left and
ow)
Vertical blade
Filter
Anion
generator
(inside)
right air fl
Inlet
1
2
3
31. CODE
2
TEMP display
Display board
COOL: blue
AUTO: white
HEAT: red
DRY: cyan
FAN: yellow
: green
Nano-Aquo
Aureole
Display modethe aureole display different
colour when setting different function
Nano-Aquo
Generator
inside
The following functions and related displays are not available
31
30
28
19
Operation mode
AUTO
FAN
COOL DRY
Remote controller
HEAT
3. TIMER button
4. CLOCK button
5. SLEEP button
6. MODE button
7. HOUR button
8. HEALTH button
9. ON/OFF button
10. TIMER ON display
11. FAN SPEED display
LOW HI
MED AUTO
12. LOCK displ
ay
13. SWING display
14. SLEEP display
15. HEALTH display
16. Operation mode display
18. POWER/SOFT display
19. Left/right air flow display
20. TEMP display
21. TIMER OFF display
22. TIMER display
23. TEMP button
24. FAN SPEED button
25. HEALTH AIRFLOW button
26. SWING UP/DOWN button
27. SWING LEFT/RIGHT button
28. SET button
29. POWER/SOFT button
17.Singal sending display
30
.
LOCK
button
When the remote controller
RESET button
appears abnormal,use a
sharp pointed article to press
this button to reset the remote
controller controller normal.
1
.
2.LIGHT button
Control the lightening and
extinguishing of the indoor
LED display board.
If pressed, the other buttons will be
disabled. Press it once again, lock
will be cancelled.
31
Used to select CODE A or B with a
press, A or B will be displayed on LCD.
Please select A without special
explanation.