Filter
Top Products
11
11
When unit has cooled, remove
pads or scrub brushes. Store
unit upright in a dry area.
10
Place unit with pads/scrub
brushes attached onto Floor
Protector / Resting Mat. Allow
to cool down for five (5) min.
Cleaning Pads and Scrub Brush Attachments
IMPORTANT:
Vibration Sound
IMPORTANT IMPORTANT
Buffing Pads
Ultra-Microfiber Cleaning Pads
Scrub Brush Attachments
During use it’s normal to
hear a “clicking” sound
coming from the unit. This
sound is produced by
the water being pumped
through the unit.
Always empty the water tank
once you have finished using
the Multiforce™.
When removing the pads or scrub brushes from the unit DO
NOT turn unit upright or on its side. ALWAYS lift unit UP off
the pads or scrub brushes.
Ideal when using CR-motion
™
without steam. Can be
used with a floor agent to polish and shine. See page 8
for care instructions.
Ideal when using the steam function by itself or with CR-
motion
™
activated. Great for cleaning laminate, hard-
wood, tile and vinyl surfaces. Can also be used to “blot”
fresh stains on carpet. See page 8 for care instructions.
Ideal when using CR-motion
™
with or without steam.
Great for outdoor use on decks, patios and walkways.
Best when used with a cleaning agent. To clean Scrub
Brush Attachments rinse with water.
PUSH
PUSH
PUSH
NOTE: It may be helpful to apply the floor agent with the Ultra-Microfiber Cleaning Pads and finish with the Buffing Pads
Do not use on unsealed wood or unglazed ceramic floors. On surfaces that have been treated with
wax or some no-wax floors, the sheen may be removed by heat and steam. It is always recommended
to test an isolated area of the surface to be cleaned before proceeding. We also recommend that you
check the use and care instructions from the floor manufacturer.