Filter
Top Products
-10- G9956 Heavy-Duty Hanging Air FilterG9956 Heavy-Duty Double Air Filter -10-
Hanging the Filter
The double air filter may
fall and cause serious
injury if it is not properly
mounted. DO NOT fasten it
to sheet rock, press board,
paneling or anything other
than joists.
Lag eyebolts
in joists
Joists
Figure 5. Hanging from the joists.
1. If the joists are covered by sheet rock, press
board, paneling or other covering, use a stud
finder to locate them, and mark their c
en-
ters.
2. Pre-drill
1
/4" pilot holes into the marks on
the joists. This will make threading the lag
eyebolts much easier and reduce the risk of
splitting the joists.
3. Thread the eye bolts into the pilot holes. Be
sure to thread the eye bolts at least 1
1
/2" into
the joists.
4. Measure the desired length of your chains
from the eyebolts. Remember to account
for the connecting links and eyebolts on the
double air filter.
5. Cut the chain to equal lengths and attach a
connecting link to each end.
6. Secure a length of chain to each mounting
eye.
7. GET SOME HELP! With at least one other
person supporting the weight of the double
air filter, connect the chains to the lag eye
bolts.
NOTE
—DO NOT use hooks in place of lag eye
bolts. If the double air filter is bumped it could
fall.
Hardware Needed (not included) Qty
Chain, rated 150 lbs. or higher ...................varies
Connecting link ..................................................
8
Lag eye bolts
5
/16" x 3" or 4" ............................... 4
Tools Needed
Drill ................................................................... 1
Drill bit
1
/4" .......................................................... 1
Follow these steps and refer to Figure 5
when
hanging the double air filter.