Filter
Top Products
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is
RED and located inside the packaging, taped to the top box. Be sure you
DO NOT discard any pieces.
Step 1
Locate the base and place it on the floor. DO NOT put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel to insert several wingnuts, lock washers and firebox screws.
Step 2
Locate the left side panel and the left front panel. Facing the
front of the base, take the left side panel, positioning it so the
holes in the blocks on the bottom line up with the holes on the
base. Position the left front panel next to the left side panel, lining
up the holes in the blocks with the holes on the base. Attach the
left front and side panel to the base by inserting and tightening
1 wingnut and 1 lock washer to each piece. Attach the left side
and front panels together by inserting and tightening 2 wingnuts
and 2 lock washers.
Step 3
Repeat Step 2, but with the right side panel and the right
front panel.
2