Filter
Top Products
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is
RED and located inside the packaging, taped to the top box. Be sure you DO
NOT discard any pieces. Use an appropriate screwdriver to insert and tighten all screws.
Step 1
Locate the base and place it on the floor. DO NOT put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel to insert several wingnuts, lock washers and firebox screws.
Step 2
Locate the left side panel and the left front panel. Facing the
front of the base, take the left side panel, positioning it so the holes
in the blocks on the bottom line up with the holes on the base. Position the left
front panel next to the left side panel, lining up the holes in the blocks with the
holes on the base. Attach the left front and side panel to the base by inserting
and tightening 1 screw to each piece. Attach the left side and left front panels
together by inserting and tightening
3 screws.
Step 3
Repeat Step 2, but with the right side panel and the right front panel.
2