Filter
Top Products
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is
RED and located inside the packaging, taped to the top box. Be sure you DO
NOT discard any pieces.
Step 1
Locate the base and place it on the floor. DO NOT put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel to insert several wingnuts, lock washers and firebox screws.
Step 2
Locate the left side panel and the left front panel. Facing the
front of the base, take the left side panel, positioning it so the holes
in the blocks on the bottom line up with the holes on the base. Position
the left front panel next to the left side panel, lining up the holes in the
blocks with the holes on the base. Attach the left front and side panel
to the base by inserting and tightening 1 wingnut and 1 lock washer
to each piece. Attach the left side and front panels together by
inserting and tightening 3 wingnuts and 3 lock washers.
Step 3
Repeat Step 2, but with the right side panel and the right
front panel.
2