Filter
Top Products
Warnings
Warnings
The following
warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation p
oint symbol alerts you to a general warning and the hazard symbols refer to procedure-specific
risks. When th
ese symbols appear in the body of this manual or on warning labels, refer backtothese
Warnings. Pr
oduct-specific hazard symbols and warnings not covered in this section may appear throughout
the body of th
is manual where applicable.
WARNING
FIRE AND EXPLOSION HAZARD
Flammable
fumes, such as solvent and paint fumes, in work area can ignite or explode. To help
prevent fir
e and explosion:
• Use equipment only in well ventilated area.
• Eliminate
all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and
plastic d
rop cloths (potential static arc).
• Keep work area free of debris, including solvent, rags and gasoline.
• Do not plug or unplug power cords, or turn power or light switches on or off when flammable
fumes are present.
•Grounda
ll equipment in the work area. See Grounding instructions.
• Use only grounded hoses.
• Hold gun firmly to side of grounded pail when triggering into pail. Do not use pail liners unless
they are antistatic or conductive.
• Stop op
eration immediately if static sparking occurs or you feel a shock. Do not use
equipm
ent until you identify and correct the problem.
• Keep a working fire extinguisher in the work area.
• Route exhaust away from all ignition sources. If diaphragm ruptures, fluid may be exhausted
with air.
Static charge may build up on plastic parts during cleaning and could discharge and ignite
flammable vapors. To help prevent fire and explosion:
• Clean
plastic parts only in well ventilated area.
• Do not clean with a dry cloth.
• Do not operate electrostatic guns in equipment work area.
PRESSURIZED EQUIPMENT HAZARD
Fluid from the equipment, leaks, or ruptured components can splash in the eyes or on skin
and cause serious injury.
•Fol
low the Pressure Relief Procedure when you stop spraying/dispensing and before
cle
aning, checking, or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.
3A2888A 3