Filter
Top Products
Installation
6 312769D
Installation
Grounding
The equipment must be grounded. Grounding reduces
the risk of static and electric shock by providing an
escape wire for the electrical current due to static build
up.
Connect grounding wire to grounding screw (Z) on back
of XM sprayer or any earth ground.
Install Feed Pump
NOTE: President 10:1 feed pump kit 256433 is only
recommended for drum feed applications and highly
viscous materials. Do not install in hoppers as this
will result in pulsation at the gun. See page 11 for
parts.
1. Refer to Setup instructions in pump manual before
installing in drum or hopper (H).
2. If installing either the pump in a drum, install pump
in drum and use bung adapter (B) to secure.
3. If installing the T2 pump in a hopper: Install T2
pump in lower ledge of hopper (H), and secure with
bung adapter (B).
4. If installing 5:1 pump in a hopper:
a. Install 5:1 pump in lower ledge of hopper (H).
b. Drop in bung adapter (B).
c. Install spacer (C).
FIG. 1: XM Sprayer
Z
r_256275_312769_5A
ti18686a
H
1
B
8
7
T2 2:1 pump shown in 20 gallon hopper
ti18687a
1
22
B
H
7
8
5:1 pump shown in 20 gallon hopper
C