Filter
Top Products
The integrated air valves, have a common air inlet (1/4" NPT) port and two outlet ports A and B (1/4” Tube) toward
the front of the unit. The exhaust is silenced with a muffler. Do not exceed 120 psi at the air inlet to the unit. Refer to
your pump owner’s manual for the maximum air pressure limit of the pump.
Failure to use the following recommended valve can cause damage to the unit and possible
personal injury. Follow the pressure relief procedure in the pump manual before moving or
servicing the pump.
The A and B outlet ports are to be connected to the A and B ports respectively on the Husky 205, or to the two air
valve control ports located on the air motors of pumps larger than the Husky 205. On pumps larger than the Husky
205, a three way solenoid valve (Graco Part Number 115606 or equivalent) MUST be installed on the main air
supply to the pump. This ensures that pressure is not generated by the pump when the controller is not operating.
The same signal used to start the CycleFlo II controller can also control this valve.
7 309004
B Outlet
Port
Exhaust
Muffler
Common
Air Inlet
Strain Relief
for Power
Supply LIne
A Outlet
Port