Open as PDF
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 1958, Graco Inc. is registered to I.S. EN ISO 9001
3:1 Ratio Bulldog
- For use in lubrication applications only -
With inductor, guide bars and release bar
Model: 205148, Series E
Without inductor, guide bars and release bar
300 psi (2.1 MPa, 21 bar) Maximum Working Pressure
100 psi (0.7 MPa, 7 bar) Maximum Air Input Pressure
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
Use with lubrication applications only! This pump is
designed to be used for pumping non-corrosive and
non-abrasive lubricants and greases only. Any other use of
the pump can cause unsafe operating conditions and result
in component rupture, fire or explosion, which can cause
serious bodily injury.
Priming Piston Hazard
This pump has a priming piston which extends below the
foot valve during operation. This piston could pinch or
amputate your fingers or hands as it moves up, into the cyl-
inder. To reduce the risk of injury, keep your fingers and
hands and all tools away from the priming piston during
operation and whenever the air and fluid pressure in the
pump is not fully relieved.