Filter
Top Products
9
9. Insert a Pad Tube (19) into the Leg Lever (3).
Slide two Foam Pads (20) onto the Pad Tube.
Then, press two 19mm Round Inner Caps (46)
into the Foam Pads.
Repeat this step with the other two Pad Tubes
(19).
12. Make sure that all parts are properly tightened
before the weight bench is used.
The use of all
remaining parts will be explained in ADJUST-
MENT, starting on the next page.
10. Attach the Curl Pad (15) to the Curl Post (11) with
two M6 x 20mm Screws (39).
20
20
19
9
10
46
46
3
15
11
39
1
1. Attach the Bumper (17) to the Curl Bar (8) with an
M4 x 16mm Screw (45).
1
1
8
17
45
8
. Next, orient the Seat (14) as shown. Attach the
Seat to the Bench Frame (1) with four M6 x
20mm Screws (39).
8
39
1
14
19
19