Filter
Top Products
7
2. Attach the Bench Frame (1) to the Front Leg (2)
with two M10 x 65mm Bolts (40), two M10
W
ashers (44), and two M10 Nylon Locknuts (43).
Do not tighten the Locknuts.
4. Attach the Weight Tube (16) inside the Leg Lever
(3) with an M8 x 60mm Bolt (52), two M8
Washers (35), an 11mm Spacer (32), and an M8
Nylon Locknut (47).
Make sure that the Spacer
is inside the Leg Lever
.
Press the 25mm Round Angled Cap (28) onto the
W
eight
T
ube (16).
Grease an M10 x 55mm Bolt Set (51). Attach the
Leg Lever (3) to the Front Leg (2) with the Bolt
Set.
Make sure that the barrel of the Bolt Set
is inserted into both sides of the bracket on
the Front Leg.
Attach a Tether (9) to the Leg Lever (3) with an
M4 x 16mm Screw (45).
3. Attach the Bench Frame (1) to the Crossbar (4)
with two M10 x 85mm Bolts (41) and two M10
Nylon Locknuts (43).
Tighten the M10 Nylon Locknuts (43) used in
steps 1 through 3.
1
2
40
40
44
43
2
3
1
41
43
41
4
51
2
51
47
9
3
28
45
35
16
52
32
Grease
4
35