Filter
Top Products
HR3030 ELECTRIC HORSEPOWER
REQUIREMENTS
RPM GPM 1500 PSI 2000 PSI 2500 PSI 3000 PSI
3450 3.0 3.1 4.1 5.1 6.2
Specifications
Model HR3030
Axial Pump
Volume HR3030....................................................................................3.0 GPM
Maximum Discharge Pressure .............................................................3000 PSI
Maximum Inlet Pressure ......................................................................Up to 90 PSIG
1
RPM .....................................................................................................3450
Plunger Diameter..................................................................................16mm
Stroke....................................................................................................5.9mm (8.0
o
angle)
Crankcase Oil Capacity ........................................................................4.5 fl. oz.
Temperature of Pumped Fluids.............................................................Up to 80
o
F
Inlet Port ...............................................................................................1 x 1/2" NPT
Discharge Ports ....................................................................................3/8" NPT
Shaft Rotation .......................................................................................Clockwise
Weight ...................................................................................................11.4 lbs.
Width .....................................................................................................6-7/16"
Height ...................................................................................................10-1/4"
Swash Plate Bore .................................................................................1"x3/16" Keyway
Valve Type ............................................................................................Polyamide Plastic
1
A 25 PSIG minimum inlet pressure is required.
HORSEPOWER RATINGS:
The rating shown are the power
requirements for the
pump. Gas
engine power outputs must be
approximately twice the pump power
requirements shown above.
We recommend a 1.15 service factor
be specified when selecting an
electric motor as the power source.
To compute specific pump horse-
power requirements, use the Follow-
ing formula:
Electric HP = (GPM X PSI) / 1460
Gas HP = (GPM X PSI) / 1100
HR3030 GAS HORSEPOWER
REQUIREMENTS
RPM GPM 1500 PSI 2000 PSI 2500 PSI 3000 PSI
3450 3.0 4.1 5.5 6.8 8.2
5