Filter
Top Products
3
U.S. .............................. Metric
Volume.................................................................23.5 GPM ..................... 88.9 LPM
Discharge Pressure .............................................. 3045 PSI ....................... 210 BAR
Speed .......................................................................................................... 800 RPM
Inlet Pressure ....................................................... -4.35 to 145 PSI .................... -0.3 to 10 BAR
Plunger Diameter................................................. 1.26”............................. 32mm
Plunger Stroke ..................................................... 1.89”............................. 48mm
Crankshaft Diameter............................................1.65” ............................. 42mm
Key Width............................................................0.47” ............................. 12mm
Crankshaft Mounting.................................................................................. Either side
Shaft Rotation ......................................................Top of pulley towards manifold
Temperature of Pumped Fluids ...........................Up to 140
o
F ................. 60
o
C
Inlet Ports ................................................................................................... (2) 1-1/4" BSP
Discharge Ports........................................................................................... (2) 2-1/2" BSP
Weight..................................................................309 lbs. ......................... 140 kg
Crankcase Oil Capacity .......................................1.1 Gal.......................... 4.2 Liters
Fluid End Material ..................................................................................... Bronze
Specifications
Model GP6132
Consult the factory for special requirements that must be met if the pump is to
operate beyond one or more of the limits specified above.
HORSEPOWER RATINGS:
The rating shown are the power requirements for the pump. Gas engine power outputs must be approxi-
mately twice the pump power requirements shown above.
We recommend a 1.15 service factor be specified when selecting an electric motor as the power source. To
compute specific pump horsepower requirements, use the following formula:
HP = (GPM X PSI) / 1450
RPM GPM 1000 PSI 1500 PSI 2500 PSI 3045 PSI
400 11.8 8.1 12.2 20.3 24.7
500 14.7 10.1 15.2 25.3 30.8
600 17.6 12.2 18.2 30.4 37.0
700 20.6 14.2 21.3 35.5 43.2
800 23.5 16.2 24.3 40.5 49.4
GP6132 HORSEPOWER REQUIREM ENTS