Genie 4024 Garage Door Opener User Manual


 
©2010 The Genie Company 12/2010
10
PROGRAM
SET
+
PROGRAM
SET
+
PRESS and HOLD
SEE BOTH
Blue LEDs
come ON
SEE one
Blue LED
come ON
PRESS and release a previously programmed
Genie® IntelliCode® 2 remote button on
remote. If you are unsure which remote you
have see page 16. Remote must be IntelliCode®
2 enabled.
RELEASE
1 2 3 4
OPTIONAL PROGRAMMING POWERHEAD TO
Homelink®, Car2U®, or IntelliCode® 1 REMOTES and IntelliCode® 1 WIRELESS KEYPADS
To complete any of these tasks you MUST have at least one Genie® IntelliCode® 2 remote
button already programmed to the powerhead present.
For Homelink® or Car2U®: You must also have your Homelink® or Car2U® enabled vehicle
present and their programming instructions to perform these programming steps.
For Genie® IntelliCode® 1 remote: You must also have your Genie® IntelliCode® 1 remote
present.
For Genie® IntelliCode® 1 wireless keypad: You must also have your Genie® wireless
keypad installed and a PIN already programmed into the keypad. Programming instructions
for Genie® IntelliCode® 2 wireless keypad will come with the wireless keypad.
PRESS and
RELEASE
5
On the IntelliCode® 1 remote
PRESS a button and RELEASE. SEE
long LED come ON Purple.
6
IntelliCode® 1 remote or wireless keypad programming
7
On the IntelliCode® 1 remote
PRESS the same button and
RELEASE.
SEE both LEDs on the powerhead
come ON Blue. The next press of
the remote will operate door.
Test. Repeat as necessary for any
other IntelliCode® 1 remotes.
Genie® IntelliCode® 1 remote Genie® IntelliCode® 1 wireless keypad
SEE long Purple
LED flashing
SEE both LEDs
flash Purple
All optional programming is complete. Your garage door opener is ready to use.
5
For Car2U® enabled vehicles follow the Car2U®
instructions.
6
Test. Repeat as necessary for any other Car2U®
enabled vehicle.
Homelink® programming
If your Homelink® has been previously programmed to an
Genie® opener begin with Step 1 and continue through Step
5 and 6 of the Homelink® section below.
If your Homelink® has not yet been linked to a Genie®
opener then go to page 16 and change one remote button
from IntelliCode® 2 to IntelliCode® 1, then program
that button with the car Homelink® using Homelink®
instructions and repeat steps 1-4 then continue with
Homelink® steps 5-6.
5
6
PRESS the Homelink® button twice.
Test. Repeat as necessary for any other pre-
programmed Homelink® enabled vehicle.
5
Enter your wireless keypad PIN.
6
Press and hold button 1 second
then release and see on powerhead
long LED come ON Purple.
7
Press and hold button 1
second again then release and see on
powerhead both LEDs flash Blue.
8
Press and hold button again and
opener will activate
9
Wait 30 seconds, enter pin and press
button to verify operation.
Homelink® or Car2U® programming