Filter
Top Products
Installation Instructions
10
CONNECT TO ELECTRICAL POWER
To gain access to the transformer/power cord
assembly, remove the salt hole cover from the
softener. Unclip the tabs on the rear of the top cover
and rotate the cover upward to remove. DO NOT
PULL OR DISCONNECT WIRING.
• The softener works on 24 volt-60Hz electric
power. The included transformer changes
standard 120-volt AC house power to 24 volts.
Plug the transformer into a 120-volt outlet only.
Be sure the outlet is always live so it can not be
switched off by mistake.
• Replace the top cover.
• Replace the salt hole cover.
9
PROGRAMMING THE CONTROL
PROGRAMMING THE CONTROL
CONTROL SETTINGS REQUIRED upon installation
and after an extended power outage.
NOTES:
• WHEN THE TRANSFORMER IS PLUGGED INTO
THE ELECTRICAL OUTLET, 12:00 PM (flashing), and
PRESENT TIME is displayed. Program the control
as instructed below.
If - - - or - - - - is flashing, use the UP
button to set the correct model code as follows:
F35 for GNSF35. If you pass by the correct code
number, use the DOWN button. Then press the
SELECT button to accept the correct model.
• A “beep” sounds while pressing buttons for
control programming. One beep signals a change
in the control display. Repeated beeps mean the
control will not accept a change from the button
you have pressed, and you should select another
button.
• To program the control, you will use the UP ,
DOWN and SELECT buttons.
• Use the SELECT button to select the desired
control function.
SET PRESENT TIME OF DAY
1. Press the SELECT button until
PRESENT TIME appears in the
display.
2. Press UP or DOWN button
to set. The UP button advances
the time; the DOWN button
moves the time in reverse.
If the present time is between noon and midnight,
be sure PM shows in the display. If the present
time is between midnight and noon, be sure AM
shows in the display.
NOTE: Each press of an UP or DOWN button
changes the time by one minute. Holding the button
changes the time at a rapid rate.
3. When the present time is correct, press SELECT to
accept.
SET WATER HARDNESS NUMBER
1. Press the SELECT button until
HARDNESS appears in the
display.
2. Press UP or DOWN button
to set your water hardness number in the
display. DOWN decreases the hardness value.
UP increases the hardness value.
NOTE: Each press of a button changes the display
by 1, between 1 and 25. Above 25, the display
changes 5 at a time (25, 30, 35, etc.). Holding a
button in changes the numbers at a rapid rate.
SmartWater Softener System
TOUCH
or
HOLD
SELECT
TIME
HARDNESS
RECHARGE NOW
RECHARGE TONIGHT
Display
TOUCH or HOLD button
SELECT
button
DOWN (-)
button
UP (+)
button