GE AHH40LJ Dehumidifier User Manual


 
Using the dehumidifier.
Always make sure the water bucket is locked into place on the dehumidifier.
Removing Collected Water
There are 3 ways to remove collected water'.
[] Use the bucket. _q_en the bucket is remoxed,
the unit will shut off. Erupt)and replace the
bucket.
[]
Use a floor drain. The unit can also be placed
oxer a floor drain. Using a ddll, make a hole
at the end of the nozzle located on the lower
left side of the bucket.
[]
Usea hose. Water can be automatically
emptied into a floor drain by attaching a
water hose (not included) to the bucket hose
nozzle. Using a (lcill, make a hole at the end
of the nozzle located on the lower lett side ot
the bucket. Attach a water hose to the bucket
nozzle. Fasten bv hand only.
Drill hole: Attach hose:
Nozzle
Hose NN_
Drill
NOTE."Thenozzlecannot befixed after puncture.Use
an ordinarygardenhosecap (notincluded)toreclose
if necessan/
NOTE:Avoidusing mechanicaltools to tightenthe
water hoseto the bucket nozzle.Thismay damagethe
threadsonthe nozzle.
Installing the Water Bucket
IJfl the bucket and hook the slots on each side
onto the posts on the back of the dehumidifie_;
The bucket should lock securely in place.
Make sure the bucket is locked securely in place
by pressing down on the ul)per back edge of the
bucket. It will be firefly seated when properly
installed.
_\ Post
Water Level
The dehumidifier will mrn off automatically
when the bucket is flfll, or when the bucket is
removed or not replaced in the proper position.
The bucket must be replaced in the proper position for
the dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the
proper position.