Filter
Top Products
About the controls on thedehumidifier.
• High
Bucket
Full Fan
Humidity
Control
ControlsO POWER Pad
Press to mrn the dehmnidifier on and off,
HUMIDITY CONTROLPads
The lmmidi_' lexel can be set within a range
of 35% RH (Relafixe Hmnidity) to 70% RH
(Relatixe Hmnidit)) in 5% increments,
For drier ai_, press the • pad and set to
a lower percent xflue (%).
For damper ai_; press the • pad and set
to a higher, I)ercent.... xal ue (%).
O FAN SPEEDPad
Controls the tim speed,
Press to set to HIGH or LOWfim speed.
Set the tim control to HIGHfin" maMm um
moisture remowfl. When the hmniditv has
been reduced and quiet operation is
preferred, set the tim control to LOW,
O HUMIDITY LEVELDISPLAY
Displa)s percent hmnidit) lexel.
Its accuracy is (+/- 5%).
When vou first use the dehumidifier; set the
hmniditv control to 45% or 50%. Mlow at
least 24 hem5 fin" the dehumidifier to
achieve the humidity level. If you still have
damper air than desired, set the humidity
level to a lower setting.
O BUCKETFULLLED
Indicates presence of bucket and its
fill lexel.
4
OtherFeatures
BUCKETFULLLight
Glows when the bucket is ready to be emptied,
or when the bucket is removed or not replaced
in the proper position.
Auto Shut Off
The XAater I,e\'el Control Switch shuts off the
dehumidifier when the bucket is fifll, or when
the bucket is removed or not replaced in the
proper position. Mso, when the bucket is out
of position, the refit will beep 3 times.
Auto Defrost
X4]_en frost builds up on the cooling coils,
the compressor will cycle off' tmtil the frost
disappears. The tim continues to run.
PowerOutage
If a power outage occmTed or if the refit was
tmI)lugged, the refit will display its prior setting.
Note:If ONis in the displa> the dehumidifier is
operating confinuousl B but a specific hmnidity
level is not set. You will need to reset the
HgMIOID'CONrBOL t,, the desired level.
Auto Restart
Once power is restored after a power outage,
the refit automatically resumes operation alter
a 2 minute delay: