Filter
Top Products
Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support
9
Read completely, then follow step-by-step.
Window Requirements
■ These instructions are for a horizontal sliding
or a casement window.
■ The electrical outlet must be within reach of
the power cord.
Horizontal sliding window
■ For installation in a casement window, the
window frame assembly and the side of the
building must be adequate to support the
weight of the air conditioner.
Casement window
(See Casement Window Installation Instructions)
15
1
⁄2″
min.
1
21
1
/2″ min.
15
1
/2″
min.
16
1
/2″
max.
21″ min.
40
1
⁄2″ max.
Optional—Change the Power Cord Exit
You may change the power cord exit from the
bottom to the side, if desired, for appearance or
window sill clearance.
Grasp both sides of
the inlet grille and
pull forward. The
inlet grill will pivot
forward and down to
reveal the air filter.
Remove the filter by
grasping it by the
frame and pulling
it out.
If present, remove both screws from the
grille and retain.
Pull the grille
frame with your
thumb while
pushing the case
with your fingers.
Lift the grille
frame up and off.
Remove the right
screw from the
power cord
clamp. (Replace
screw into the
empty hole in
case the power
cord exit ever
needs to be
reversed.)
Replace the front
grille frame and
lead the power
cord out the side.
Replace the
two screws (if
removed
earlier)and the
filter, and close
the inlet grille.
G
F
E
D
C
B
A
2
Air filter
Inlet grille
Inlet grille