Filter
Top Products
10
Window Installation Instructions
INSTALL THE CASE IN THE
WINDOW
Open the window and mark the centerline
of the window stool.
Carefully place the case on the window
stool and align the center mark on the
bottom front with the centerline of the
stool.
Pull the window down behind the top
mounting rail.
NOTE: Do not shut the window so tightly that
movement of the accordion panels is
restricted.
Select the position that will place the sill
supports near the outermost point on the
sill. Place the short side of the sill supports,
on the case bottom, toward the window.
Attach the sill supports to the case track
hole in relation to the selected position
using 2 Type B screws in each support.
CAUTION: Do not install this air
conditioner in a window if the bolts do
not contact the window sill.
Adjust the bolt and the nut in each
support so that the case is installed with
a slight tilt to the outside. Use a level; no
more than 1/2 bubble will be the correct
case slant to the outside.
7
INSTALL THE CASE IN THE
WINDOW (CONT.)
Secure the case to the window stool by
using 3 Type D screws.
Pull the accordion panels to each window
sash track. Attach them on each side to the
window sash and the window stool using
4 Type C screws.
7
A
B
C
F
SECURE THE CASE IN THE
WINDOW AND INSTALL THE
FOAM TOP WINDOW GASKET
Attach the window
locking brackets (one on
each side) with Type C
screws.
Cut the foam top window gasket to the
window width.
Stuff the foam
between the glass
and the window
to prevent air
and insects from
getting into the
room.
A
B
C
8
D
Long side
of sill
supports
OUTSIDE
E
G
Sill
support