Filter
Top Products
Basic Operation 4
Figure 2. Connecting the CareGard System to the Phone Line
Plugging in the Power
The panel is pre-wired for power. Simply plug the transformer into an available standard outlet
(110 VAC).
Important !
Make sure the outlet is not controlled by a switch or part of a ground fault interrupt circuit (GFIC).
Powering up the System
Turn the Power switch on the back of the panel to On. The panel voice should announce “Hello,
system X is OK.”
Note
After power up the system may announce “System Low Battery” and the Status light will flash. It may
take several hours for the battery to fully change after it is initially plugged in.
Adjusting the Speaker Volume
The Volume button on the front of the panel controls the volume of announcements from the
speaker and the volume during a 2-way talk session.
Adjust the built-in speaker volume using the Volume button on the front of the panel. Each time
the Volume button is pressed it increases the speaker volume one level and announces the volume
level.
Adjust the volume the same way during a 2-way talk session.
Basic Operation The main function of the CareGard system is to respond to the wrist or pendant panic and the
panel Call button.
To activate a portable panic sensor:
• Wrist Panic - Press the button until its red light blinks.
• Pendant Panic - Press and hold the button for 2 seconds.
To activate the panel Call button:
Depending on how Option 21 (Call Button Enable) is set, the Call button operates with a single
press or two presses. If Option 21 is set to off, the panel Call button cannot be used to initiate an
emergency call.
To Home
To Phone or Answering
Phone Jack
Machine
LINE
PHONE
To AC Outlet
Power Switch