Filter
Top Products
7Indoor/Outdoor PIR Motion Sensors Installation Instructions
¾ To relocate a sensor:
1. Test the sensor a few inches from the original position.
2. Increase the distance from the original position and retest until an acceptable location is
found.
3. Mount the sensor in the new location.
4. If no location is acceptable, test the sensor as described below:
Test a known good sensor at the same location.
If the system does not respond, avoid mounting a sensor at that location.
If the replacement sensor functions, return the problem sensor for repair or replacement.
Specifications Compatibility:..........................Concord™, Concord Express, International Concord, Simon
®
, Euro Simon,
Quik Bridge
®
, 1 & 2 Channel Receiver, Quik Bridge Euro Repeater SAW,
Quik Bridge International Loop Receiver, SuperBus
®
, 2000 RF Receiver,
SuperBus 2000 433 MHz Receiver
Power source:...........................2 AA 1.5V alkaline batteries
Typical battery life: .................2-4 years at 68° F (20° C) not verified by UL
Transmitter Frequency:..........319.5 MHz
Operating temperature:..........32° to 120° F (0° to 49° C) Indoor Motion Sensor
10° to 120° F (12° to 49° C) Outdoor Motion
Storage temperature range:....-30° to 140° F (-34° to 60° C)
Maximum Humidity................90% Relative Humidity non-condensing
Dimensions:..............................2.9 in. (7.3cm) x 2.4 in. (6 cm) x 1.9 in. (4.8 cm) (L x W x H)
Declaration of
Conformity
Manufacturer’s Name:............GE Interlogix
Manufacturer’s Address:........2266 North 2nd Street
North St. Paul, MN, USA 55109
EU Representative:..................Interlogix Europe & Africa
Excelsiorlaan 28
B-1930 Zaventum
Belgium
Product Identification:............Product: Indoor and Outdoor PIR Motion Sensors
Model Numbers: 60-639-43-EUR and 60-639-43-EUR-OD
Brand: GE Interlogix
Means of Conformity
We declare under our sole responsibility that this product is in conformity with Directive 93/68/
EEC (CE Marking) and complies to the essential requirements of 1999/5/EC (R&TTE) based on
test results using (non)-harmonized standards in accordance with the Directives mentioned.
Concerning R&TTE
A sample of the product
has been tested by:
Mikes Product
Service
KTL Arnhem
Standards used: I-ETS 300 220
(10.1993)
EN50130-4 (1995)
EN50130-4/A1 (1998)
EN60950, 1992 (A1, A2, A3, A4, A11)
IEC950, 2nd ed. (A1, A2, A3, A4)
Test report: T14152-1-02SM 98639220
98639250