Filter
Top Products
Installation using the provided screws:
1. Remove the old push button and use
this location to install your new Push
Button.
2. Remove the battery cover as
described in the installation of the
battery.
3. Use the battery cover as a template to
mark the position of the screws.
4. Using a 1/16th inch drill bit, drill a pilot
hole for each screw.
5. Using a Phillips head screwdriver,
mount the back cover using the
screws provided. (Note: The back
cover has an arrow and the word “Up”
embossed on the inside of the cover. Position the back cover with the
arrow pointing upwards and the word “Up” is at the top)
6. Press the Push Button on to the back cover by inserting the top of the
Push Button onto the top of the back cover first and then pressing on the
bottom of the Push Button to snap the bottom of the Push Button into
place.
Installation using the provided Double Sided Tape:
1. Clean the surface where you would like to mount the Push Button and
the back of the Push Button. Use a mixture of 50/50 water to isopropyl
alcohol.
2. Remove the battery cover as described in the installation of the battery.
3. Remove the backing from one side of the double sided tape and press it
onto the back of the back plate of the Push Button.
4. Remove the backing from the other side of the double sided tape and
press the back plate to the cleaned mounting surface. (Note: The back
cover has an arrow and the word “Up” embossed on the inside of the
cover. Position the back cover with the arrow pointing upwards and the
word “Up” is at the top)