Filter
Top Products
Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support
Prepare the Window
Mark the centerline of the stool. Measure
from the centerline 13
3
⁄8″ on both sides
for the panel cuts.
Measure 12
3
⁄8″ from the centerline on
both sides for the sill support brackets.
BA
4
Install the Sill Supports
Assemble the sill supports. Do not fully
tighten the spacer mounting screws at
this time.
Before attaching the sill supports, place
them on the window stool. Select the spacer
position that will place the spacer near the
outermost point on the sill. Tighten the
spacer mounting screws.
Turn the bolts and tighten the lock nuts to
make the sill supports level or tilt down 1/8″
to the outside. Line up the “V” notch with
12
3
⁄8″marks. Drill pilot holes and attach the
sill supports.
NOTES:
■ On narrow sills, there may not be enough room
to use the lock nut.
■ A deep offset sill may require a longer adjusting
bolt than the standard hex head bolt provided.
■ On wood sills use the large washer between the
bolt head and the sill. This prevents the bolt
from digging into the wood.
C
B
A
5
13
Stool
Sill
12
3
⁄8″
13
3
⁄8″
Centerline
Centerline
Spacer
Type B
Type E
Spacer mounting
screws
Type (A)
Lock nut
Sill
support
Adjusting bolt
Large washer
(For use with wood sills)
Sill support
Average sill
Narrow sill
Offset sill (such as brick or stone)
Bolt
Sill
Stool
Sill
support
“V” notch
Screws are in position
Spacer