Filter
Top Products
20
INSTALLATION INSTRUCTIONS
INSTALLATION
It may be necessary to make small changes to the log
positioning in order to achieve the most pleasing flame
effect but the following guidelines should be followed.
5.8.1 Refer to the log identification chart and identify the
numbers corresponding to the logs that have been supplied.
See diagram 23.
5.8.2 Place the two logs (No.13) on top of the beads as shown.
See diagram 24.
5.8.3 Place the large log (No. 1) so that it sits on top of the
previous two logs. Place the burnt effect log (No. A1) in the
centre of the tray as shown. Place one log (No. 7) along
each side of the tray, another log (No. 7) along the front LH
side and a log (No. 8) along the front RH side of the tray.
See diagram 25.
5.8.4 Place two cones (No. 14), one in the RH front corner and
the other at the LH side of the burnt log. See diagram 26.
5.8.5 Place one large log (No. 6) so that it rests on top of the rear
and front logs to the LH side. Place the other large log (No.
6) so that it rests on top of the rear and front logs on the RH
side and log (No. 8) so that it bridges the centre gap as
shown. See diagram 27.
23
24
AR1278
25
AR1279
26
AR1280
27
AR1281
5.8 Log & Driftwood Layout –
Medium Chamonix, Large Aspen & Chamonix
8