Filter
Top Products
10
USER INSTRUCTIONS
7.8.5 Place one large log (No. 6) so that it rests on top of the rear
and front logs to the LH side. Place the other large log (No.
6) so that it rests on top of the rear and front logs on the RH
side and log (No. 8) so that it bridges the centre gap as
shown. See diagram 26.
It may be necessary to make small changes to the log
positioning in order to achieve the most pleasing flame
effect but the following guidelines should be followed.
7.9.1 Refer to the log identification chart and identify the
numbers corresponding to the logs that have been supplied.
See diagram 27.
7.9.2 Place a cone (No. 14) in the centre at the rear edge of the
tray and place one log (No. 13) at each side of the cone.
Place one log (No. 11) along the front of the tray at each
side of the pilot. See diagram 28.
7.9.3 Place the burnt effect log (No. B1) in the centre of the tray.
See diagram 29.
7.9.4 Place one log (No. 8) in the centre so that it rests on the
rear cone and the pilot shield. See diagram 30.
7.9.5 Place one log (No. 11) so that it rests on the LH front log
and the burnt log. Place another log (No. 7) so that it rests
on the RH front log and the burnt log. See diagram 31.
AR1281
26
AR1282
28
AR1283
29
AR1284
30
7.9 Log & Driftwood Layout – Tahoe
27
AR1285
31
8