7
USER INSTRUCTIONS
•Raketheembersevenlyoverthefirebedandopenthe
Airwash control fully for a few minutes before re-fuelling
5.2 Burn new logs at high output for a few minutes before
adjusting the Airwash control. Refuel little and often for
clean, efficient burning.
5.3 Experience establishes settings to suit personal preferences.
5.4 Do not burn large amounts of fuel with the Airwash control
closed for long periods of time. This reduces the glass
cleaning effect and causes tars and creosotes to build-up in
the appliance and flue system.
5.5 When in use, burning the appliance at high output for a
short period also reduces tars and creosote.
5.6 Burning Solid fuel:
•Setaircontrols,SeeDiagram10
Airwash
25% Open
Primary Air
Fully Open
Secondary
Combustion
Control (not 1A)
Closed
PR7225a
5.7 De-ash the fire bed before re-fuelling, See Ash Removal
•OpenthePrimary air control fully to establish a glowing
bed before adding new fuel
•Burnnewfuelathighoutputforafewminutesbefore
adjusting the Primary air control to the desired setting
•Refuellittleandoftenforclean,efficientburning.
5.8 Experience establishes control settings to suit personal
preferences
5.9 Do not burn large amounts of fuel with the Primary Air
Control on low settings for long periods of time. This
reduces the glass cleaning effect of the airwash and causes
tars and creosotes to build-up in the appliance and flue
system.
5.10 When in use, burning the appliance at high output for a
short period also reduces tars and creosote.
Air Inlets
Log Guard
AR2147
•Closethedoor
Do not leave the door open as this could over-fire and
damage the appliance.
5. RUNNING THE APPLIANCE
5.1 Burning Wood:
•ClosethePrimary air control and use the Airwash
to control the burn rate when appliance is at operating
temperature, see Diagram 9
•LeavetheSecondary Combustion control open
The position will vary between half and fully open
depending on the flue draught.
Air Wash: Adjust
PR7225a
Secondary
Combustion
Control (not 1A)
Half - Fully open
•Woodburnsbestonabedofash