Filter
Top Products
My dog is still barking
If the dog continues barking while wearing the device, you can
try any of these options to improve the effectiveness of the
device.
• Tighten the collar until it is very snug (page 2).
• Adjust the position of the device on the dog's neck (page 2).
• Wiggle the device to work the contact points through the
dog's coat.
• Gradually increase the intensity level (page 2).
Device Information
BarkLimiter Specifications
Battery type User-replaceable 3V CR2 lithium
cylindrical
Battery life 6 months, typical use
Operating temperature
range
From 5° to 140°F (from -15° to 60°C)
Water resistance IPX7
BarkLimiter Deluxe Specifications
Battery type Rechargeable, replaceable lithium-ion
Battery life 3 months, typical use
Operating temperature range From 5° to 140°F (from -15° to 60°C)
Charging temperature range From 32° to 104°F (from 0° to 40°C)
Storage temperature range (up
to 1 month)
From -4° to 122°F (from -20° to 50°C)
Storage temperature range (up
to 3 months)
From -4° to 104°F (from -20° to 40°C)
Storage temperature range (up
to 1 year)
From -4° to 68°F (from -20° to 20°C)
Water resistance IPX7
Sleep Mode
To conserve battery life, the device goes into sleep mode when
no barks or motion are detected. The activity level of your dog
affects the battery life of the device.
Checking the Battery Charge Level
Rotate the dial away from N.
The color of the status LED indicates the battery charge level
for five seconds.
Green The battery has a good charge.
Yellow The battery should be charged or replaced soon.
Red The battery should be charged or replaced immediately. Bark
correction features are disabled.
BarkLimiter Battery Replacement
Instructions
WARNING
Do not use a sharp object to remove batteries.
CAUTION
Contact your local waste disposal department to properly
recycle the batteries.
BarkLimiter Components
À
Back plate
Á
Gasket
Â
Battery
Ã
Polarity indicators
Replacing the BarkLimiter Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You also need a small Phillips
screwdriver.
You must replace the battery with a 3V CR2 lithium battery.
1
Remove the four screws from the corners of the back plate.
2
Remove the back plate.
The battery comes out with the back plate.
3
Remove the battery.
4
Install the new battery into the back plate according to the
polarity indicators engraved on the back plate.
When properly installed, the battery snaps into the back
plate.
5
Verify that the gasket is not damaged and that it is
completely seated in the groove.
6
Replace the back plate.
7
Replace the four screws to secure the back plate.
BarkLimiter Deluxe Battery Replacement
Instructions
WARNING
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use a sharp object to remove batteries.
CAUTION
Contact your local waste disposal department to properly
recycle the batteries.
Device Information 3