Filter
Top Products
Setting up your
Pump:
Connect the suction unit
and motive water hose
to the pump:
K
AL
14
GB
Attach the handle
(only for set 7940):
Connect the hoses
to the filter trough:
1. Push the 4 tubes
C
and the tube with the locking screw
D
into
the connecting sleeves
E
so that the holes
d
are in alignment.
2. Fasten the connecting sleeves
E
to the tubes
C
/
D
with
2 screws each.
3. Press the end cap
F
onto the open end of the tube
C
.
1. Push the motive water hose
A
of the pump onto the nozzle
housing
7
.
2. Ensure that the seals
H
in the union nuts of the transparent
dirty hose
I
exist.
3. Screw the dirty water hose
I
onto the
nozzle housing
7
.
4. Screw the handle/nozzle holder
J
into
the dirty water hose
I
.
5. Before and During Operation
The pump may only be used near swimming pools, garden
ponds and similar places if the pump is operated via a
residual-current-operated circuit breaker (DIN VDE 0100-702
and 0100-738).
v Position the pump on solid, even ground, protected from flood-
ing, and connect it to a 230 V mains socket.
Lay the 230 V mains connection on dry ground, protected from
carrying off into water. Take care that the pump cannot fall into
water.
V Please read the operating instructions for the pump
A and observe the notes on safety.
1. Screw the large threaded connector
K
onto the delivery con-
nection (G1) of the pump.
2. Connect the suction unit
L
and the motive water hose
A
.
(Please read the information provided in the pump operating
instructions.)
A
J
I
7
H
d d
CC DE E
d
C E
d
C EF