Fujitsu AWU24CXQ Air Conditioner User Manual


 
8
AIR CLEANING OPERATION
Use this function to remove airborne impurities such as dust, tobacco smoke and pollen and clean the air of the room.
The air cleaning operation can be used alone or combined with cooling, heating (only heating model) and dry (dehumidify-
ing) operations.
Starting air cleaning operation
1
Start the operation in any one of the following:
AUTO, COOL, HEAT, DRY or FAN.
Refer to pages 6 and 7 for information about starting these operations.
2
Press the AIR CLEAN button (Fig. 6 G).
The air clean indicator lamp will light up.
Air cleaning
During operation, the unit produces a small amount of ozone that can be smelled.
When this unit is used in combination with the ultrasonic humidifier, white particles may become attached to the dust
collection unit. If this happens, clean the dust collection unit as soon as possible. (Refer to page 14.)
The air cleaning unit cannot remove gases such as carbon monoxide and alcohol from the air. During operation, ventilate
the room often to prevent asphyxiation or suffocation.
If the intake filter is removed during operation, a safety device will stop the operation of the air cleaning unit. If this happens,
the air clean indicator lamp (green) on the indoor unit will flash after some time has passed. Use the START/STOP button on
the remote controller to stop the operation, install the intake filter, and then use the START/STOP button to restart the
operation.
Use the FAN CONTROL button to change the fan speed. (Refer to page 6.) The air cleaning unit operates most effectively at
the highest fan speed.
The air clean indicator lamp will flash to inform you that the periodic cleaning of the dust collection unit is required. (Refer
to page 14.)
Stopping air cleaning operation
1
Press the AIR CLEAN button.
The air clean indicator lamp will go out. (This will not stop the main op-
eration of the air conditioner.)
2
Press the START/STOP button (Fig. 6 M).
The OPERATION indicator lamp (green or red) will go out.