Filter
Top Products
En-17
SWING OPERATION
Begin air conditioner operation before performing this procedure.
About Swing Operation
● The SWING range is as follows:
● The SWING operation may stop temporarily when the air
conditioner’s fan is not operating or when operating at
very low speeds.
● The airflow direction can not be adjusted during SWING
operation even when the AIR FLOW DIRECTION button is
pressed.
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) on the main
unit control panel.
To stop operation, press the MANUAL AUTO button once again.
(Controls are located inside the Intake Grille.)
NOTE
The air swings between 4 and 7 by pressing the SWING
LOUVER button after selecting the air direction 6 (down-
ward) by pressing the AIR FLOW DIRECTION button.
Use this operation when you want to cool yourself for a
while after taking a bath or shower, or after coming back
home in summer months.
But, for prevention of condensation on the louver, the
swing of the air direction 4 ↔7 is automatically released
after 30 minutes and turned to the swing of the air direc-
tion 1 ↔ 3.
To select SWING Operation
Press the SWING LOUVER button (Fig. 6 R).
The SWING indicator lamp (orange) (Fig. 3 7) will light.
In this mode, the Air Flow Direction Louvers will swing automatically to direct
the airflow both up and down.
To Stop SWING Operation
Press the SWING LOUVER button (Fig. 6 R) once again.
The SWING indicator lamp (orange) (Fig. 3 7) will go out.
Airflow direction will return to the setting before swing was begun.
● When the air conditioner is operated
with the controls on the Main unit, it
will operate under the same mode as
the AUTO mode selected on the Re-
mote Control Unit (see page 8).
● The fan speed selected will be
“AUTO” and the thermostat setting
will be standard.
Cooling/Dry
mode
Fan mode
1 3, (4 7)
NOTE
1 3, 4 7