Filter
Top Products
INSTALLATION
HOW TO INSTALL
1. Identify the existing wall sleeve before installing
the unit from thelisted below.
Brand
Wall Sleeve Dimensions(inches)
Width Height Depth
White-Westinghouse 16, 17-1/:.
Frigidaire 25-1/2 15-1/4
or 22
Carrier(52F series)
General Electric
/Hotpoint 26 15-5/8 16-7/8
17-1/8
Whirlpool 25-7/8 16-1/2
or23
16-3/4
FedderstEmerson 27 16-3/4
or 19-3/4
Sears/Kenmore 25-7/8 15-17/32 16-23/32
Carrier(51S series) 25-3/4 16-7/8 18-5/8
EmersontFedders 26-3/4 15-3/4 15
Friedrich 27 16-3/4 16-3/4
NOTE: All wall sleeves used to mount the new Air
Conditioner must be in sound structural condition and
have a reargrille that securelyattaches to sleeve, or
rear flange that serves as a stop for the Air
conditioner.
2.Clean the interior of the sleeve (do not disturb
seals).
3. Repaint the sleeve if needed.
5. If thewall sleeve already has a reargrille, skip to
step 7. If the wall sleeve does not have arear grille or
Iouvered panel, install the plastic grille from the kit.
Cut the plastic mesh to match the sleeve installed.
Place the plasticgrille to theinside of thewall sleeve
at the rear flange.
Place the plastic grille
Fig. C
6.Use the 4washers and screwsto secure thegrille to
the wall sleeve.
or
Fasten the screws Fig. D
4.Redirect the Iouversat the backof the wallsleeve to
60 ° angle as shown in the Fig.B. The use of pliers is
recommended.
_ Rear Louvers
60 °
\\\\\\ ///////_
TopView
Fig, B
7.Remove the backing from the Vertical Foam and
attachthattotheinsiderightofthesleeve as shown
below.
Remove the backing from theHorizontalFoam and
attachthattotheinsidefront ofthe sleeve as shown
below.
Horizontal Foam Vertical Foam
Fig. E