Frigidaire DGGF3032KB Stove User Manual


 
15
SETTING OVEN CONTROLS
SETTING LOCKOUT FEATURE
The pad controls the Lockout feature. The Lockout
feature automatically locks the oven doors and the control
panel. It does not disable the Minute Timer or the interior
oven lights.
ToactivatetheLockoutfeature
1. Press and hold
for 3 seconds.
2. After 3 seconds “Loc” and “Control” will appear, a
beep will sound, “UPPER”, “LOWER” and “DOOR” will
ash in the display. Once the oven doors are locked the
DOOR” will stop ashing and remain on along with
the “Loc”, “Control” and the icon will appear.
Toreactivatenormaloperation:
1. Press and hold
for 3 seconds. A beep will sound.
The “UPPER”, “LOWER” and “DOOR” will ash in the
display until the oven doors have completely unlocked
and the icon will disappear.
2. The unit is again fully operational.
SETTING MINUTE TIMER
The TIMER ON
.
OFF pad controls the Minute Timer feature.
The Minute Timer serves as an extra timer in the kitchen
that will beep when the set time has run out. It does not
start or stop cooking. The Minute Timer feature can be
used during any of the other oven control functions. Refer
to “Minimum and Maximum Control Pad Settings” for time
amount settings.
To set the Minute Timer (example for 5 minutes)
1. Press TIMER ON
.
OFF. -- --” will appear in the
display.
2. Use the number pads to set the desired time in the
display; press 5.
3. Press START. The time will begin to count down with
5:00” in the display.
Note: If START is not pressed the timer will return to the
time of day after 25 seconds.
4. When the set time has run out, “End” will show in
the display. The clock will sound with 3 beeps every 5
seconds until TIMER ON
.
OFF is pressed.
To cancel the Minute Timer before the set time has
run out
1. Press TIMER ON
.
OFF. The display will return to the time
of day.
SETTINGADD1MINUTEFEATURE
The ADD1MINUTE pad is used to set the Add 1 Minute
feature. When the ADD1 MINUTE pad is pressed, 1
minute is added to the Minute Timer feature if this feature
is already active. If the Minute Timer feature is not active
and the ADD1MINUTE pad is pressed, the Minute Timer
feature will become active and will begin counting down
from 1 minute.
SETTING SILENT CONTROL OPERATION
The DELAY START and SELF CLEAN pads control the
Silent Control operation feature. The Silent Control operation
feature allows the oven control to be operated without
sounds or beeps whenever necessary. If desired the control
can be programmed for silent operation and later returned
to operating with all the normal sounds and beeps.
Tochangecontrolfromnormalsoundoperationto
silentcontroloperation
1. To tell if your range is set for normal or silent operation
press and hold DELAY START. “----” will appear and
DELAY” will ash in the display. After 6 seconds “bEEP
On” or “bEEP OFF” will appear in the display.
2. Press SELF CLEAN to switch between normal sound
operation and silent operation mode. The display will
show either “bEEP On” or “bEEP OFF”.
Note: If “bEEP On” appears, the control will operate with
normal sounds and beeps. If “bEEP OFF” appears,
the control is in the silent operation mode.
3. Press START to accept the change or press CANCEL
to reject the change.
Note: The control will always beep at the end of a minute
timer and will beep when a set temperature has been reached,
even if the control is set to silent operation.