Filter
Top Products
8
TO USE THE ENERGY SAVER
FEATURE:
DO THIS:
PRESS ENERGY
SAVER BUTTON
Note: In this mode, the fan will continue to run for 3 minutes
after the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the room temperature is
above the set temperature, at which time the compressor turns
back on and cooling stars.
YOU WILL SEE:
Air Conditioner Features
(continued)
LIGHT On
TIMER: DELAY STOP / START
FEATURE
DO THIS:
PRESS
TIMER BUTTON
YOU WILL SEE: TIMER SETTING
LIGHT On
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
To adjust timer setting, tap or hold the UP arrow(
) or the DOWN
arrow(
) to change delay timer at .5 hour increments, up to 10
hours, then at 1 hour increments up to 24 hours. The control will count
down the time remaining until start (8, 7.5, 7, etc.). The Delay Start
mode automatically selects cooling with maximum Fan Speed. The
temperature maintained will be the same as previously set. To change
the set temperature, press “COOL” then Up or Down arrows until the
desired temperature is indicated on the display. After 5 seconds, the
control will automatically change the display back to the hours re-
maining until the unit will start/stop. Turning the unit “ON” or “OFF” at
any time will cancel the Delay Start/Stop function.
The Delay Start/Stop Feature will work until the unit either starts or
stops. Once that happens the above steps have to be repeated again.
.
.
0.5
.
72
.
8.5
DO THIS:
PRESS
SLEEP BUTTON
.
.
88
88
Note: In this “MODE” the selected temperature will increase by
2 degrees F 30 minutes after the mode is selected. The
temperature will then increase by another 2 degrees F after an
additional 30 minutes. This new temperature will be maintained
for 7 hours before it returns to the originally selected
temperature. This ends the “Sleep” MODE and the unit will
continue to operate as originally programmed. The “Sleep”
MODE program can be cancelled at any time during operation
by again pressing the “Sleep” button.
YOU WILL SEE:
SLEEP FEATURE:
LIGHT On
THEN
DO THIS:
PRESS
TEMP/TIMER
BUTTON